| Al 5052 합금 후판재의 전자빔 용접부 단면 형상과 강도에 관한 연구 |
|
, , , , |
| |
| A Study on Electron Beam Weldmetal Cross Section Shapes and Strength of Al 5052 Thick Plate |
|
In-Ho Kim, Gil-Young Lee, Jeong-Min Ju, Kyoung-Tae Park, Byong-Sun Chun |
|
|
| Abstract |
|
This present paper investigated the mechanical properties and the microstructures of each penetration shapes classifying the conduction shape area and the keyhole shape area about electron beam welded 120(T)mm thick plated aluminum 5052 112H. As a result the penetration depth is increased linearly according to the output power, but the aspect ratio is decreased after the regular output power. In the conduction shape area, the Heat affected zone is observed relatively wider than the keyhole shape area. In the material front surface of the welded specimen, the width is decreased but the width in the material rear surface is increased. After the measuring the Micro Vikers Hardness, it showed almost similar hardness range in all parts, and after testing the tensile strength, the ultimate tensile strength is similar to the ultimate tensile strength of the base material in all the specimens, also the fracture point was generated in the base materials of all the samples. In the result of the impact test, impact absorbed energy of the Keyhole shape area is turned up very high, and also shown up the effect about four times of fracture toughness comparing the base material. In the last result of observing the fractographs, typical ductile fraction is shown in each weld metal, and in the basic material, the dimple fraction is shown. The weld metals are shown that there are no other developments of any new chemical compound during the fastness melting and solidification. |
| Key Words:
Electron beam welding, Aluminum alloy, Thick Aluminum plate, Vacuum chamber, Full penetration |
|
PDF Links
Full text via DOI
Download Citation
